INSTALLATION INSTRUCTIONS
VOLT
®
Elevator Path & Area Light
VPL-3024-BBZ
w w w . v o l t l i g h t i n g . c o m
- 6 -
[email protected] • 813.978.3700
Wire Connections
6
Pigtail
Main Supply Cable
Wire Connectors
- 7 -
Install Fixture to Stake
5
Fixture
Pigtail
Wireway Slot
Stake
Install Stake
4
Board
Stake
Soil
Ground
Clear away the area on the
ground at the wireway slot in top
of stake. Lay the luminaire pigtail
into the wireway slots and thread
the fixture into stake. Tighten
until snug using the lock nut to
secure it to the base.
Determine your desired location for
mounting the fixture. Hammer the
stake into the ground until the flange
of the stake is flush to grade. To avoid
damage to the stake, place a board on
top of the stake while hammering.
NOTE: If ground is hard and the stake
is difficult to install, make a crosscut
in the ground using a flat shovel.
Strip both leads from luminaire pigtail. Using two wire connectors
(Sold Seperately), connect the leads from the luminaire to themain
supply cable leads.
