INSTALLATION INSTRUCTIONS
w w w . v o l t l i g h t i n g . c o m
VOLT
®
Regal Path & Area Light
VPL-1012-BBZ
[email protected] • 813.978.3700
Install Fixture Body to Stake
5
Fixture Body
Stake
Pigtail
Wireway Slot
Remove Hat and Inner Shield
2
Remove the finial and the hat from the
inner shield. Pull the inner shield off of
the fixture body to expose the socket.
Finial
Fixture
Body
Inner Shield
Install Lamp
3
Insert the bulb with the correct
wattage and type marked on the
fixture label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch bulb with bare
hands. Use a soft cloth to handle bulb.
Socket
Bulb
Install Stake
1
Board
Stake
Soil
Ground
- 4 -
- 5 -
Install Hat and Inner Shield
4
Push the inner shade onto the fixture
body. Place the hat back onto the
inner shield and secure with the finial
previously removed. Hand tighten.
Hat
Fixture
Body
Inner Shield
Determine the desired location for mounting
the fixture. Hammer the stake into ground
until flange of stake is flush to grade. To avoid
damage to the stake, place a board on top of
the stake while hammering.
NOTE: If the ground is hard and the stake is
difficult to install, make a crosscut in ground
using a flat shovel.
Clear away area in the ground at the
wireway slot on top of the stake. Lay
the luminaire pigtail into the wireway
slot and thread the stem into the
stake. Tighten to secure the base.
Hat
Finial
