VOLT
®
Integrated LED Gentle & Big Splash
VFL-4601-BBZ & VFL-4602-BBZ
Important: Please Read Before Installation
INSTALLATION INSTRUCTIONS
!
w w w . v o l t l i g h t i n g . c o m
[email protected] • 813.978.3700
Package Contents
A. (1) Fixture Body
Product Dimensions
3.25”
2.5”
1.5”
2.5”
- 2 -
- 3 -
B. (1) Stake
This fixture is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes
and instructions may result in serious injury, property damage and void
the warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations.
1. Make sure that the power is turned OFF before installing or servicing
this fixture.
2. Warning: this fixture is not intended to be installed within 10 feet [3
meters] of a pool, spa or fountain.
3. This fixture is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Underground Low Energy Cable must not be buried over 6” (15.2 cm) in
order to connect to the main low voltage cable.
5. Wiring connections must be made with wire connectors that are suitable
for outdoor use.
6. Position the wire connector so that it is located within 6 inches (15.2
cm) from a building structure, a luminaire, or fitting.
Important Safety Instructions
!
LIGHTED LAMP IS HOT!
WARNING – TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before reducing lamp.
2. Lamp gets HOT quickly!
3. Do not touch the hot lens, guard or cowl.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time.
6. Use a soft cloth.
7. Oil from skin may damage lamp.
8. Do not operate the fixture with a damaged or missing lens or shield.
Install Stake
1
Board
Stake
Soil
Ground
Determine your desired location for
mounting the fixture. Hammer the
stake into the ground until flange
of stake is flush to grade. To avoid
damage to the stake, place a board on
top of the stake while hammering.
NOTE: If the ground is hard and the
stake is difficult to install, make a
crosscut in the ground using a flat
shovel.
