INSTALLATION INSTRUCTIONS
w w w . v o l t l i g h t i n g . c o m
[email protected] • 813.978.3700
- 4 -
- 5 -
VOLT
®
12V Brass Flood Light with Yoke Mount
VFL-450X-BBZ
Install Stake
1
Install Fixture Body to Stake
2
Board
Ground
Soil
Stake
Adjust Fixture Body Direction
4
Wire Connections
3
Determine the desired location
for mounting the stake. Hammer
the stake into the ground until
flange of stake is flush to grade.
To avoid damage to the stake,
place a board on top of the stake
while hammering.
Note: If the ground is hard and
the stake is difficult to install,
make a crosscut in the ground
using a flat shovel.
Ground
Fixture Body
Supply Wires
Hex Nut
Yoke Mount
Coupler
Soil
Stake
Thread the coupler onto the
stake. Place the yoke mount
of the fixture body over the
coupler and secure with the
hex nut. Hand tighten until
snug.
Main Supply Cable
Fixture Wires
Wire Connectors
Strip both leads from the fixture wires. Using two UL listed wire
connectors (sold separately), connect the leads from the fixture wires
to the main supply cable leads.
Screw
Wrench
Rotate
Fixture Body
Adjust the fixture body to the
desired orientation and tighten
the screws with the wrench.
After installation,
A. Check to make sure the fixture is mounted properly.
B. Check to make sure the wires are connected properly.
Last, turn on the power and check if the lighting fixture works. If not,
turn off the power and contact your local electrician.
