w w w . v o l t l i g h t i n g . c o m
INSTALLATION INSTRUCTIONS
- 4 -
Install Fixture to Stake
2
VOLT
®
Low Voltage Landscape Lighting
VFL 12V Floodlights
Install Stake
1
Determine the desired location for
mounting the fixture. Hammer the
stake into the ground until flange
of stake is flush to grade. To avoid
damage to the stake, place a board
on top of the stake while hammering.
NOTE: If the ground is hard and the
stake is difficult to install, make a
crosscut in the ground using a flat
shovel.
Board
Stake
Soil
Ground
Fixture
Coupler
Stake
Pigtail
Wireway Slot
Hex Nut
Clear away an area in the ground
at the wireway slot on top of the
stake. Pass the supply wires from
the fixture through the hex nut,
yoke mount and coupler. Then, lay
the supply wires pigtail into the
wireway slot and screw the coupler
onto the stake. Place the yoke
mount onto the coupler and secure
it with the hex nut. Tighten until
snug to secure the fixture.
Yoke
Mount
