INSTALLATION INSTRUCTIONS
w w w . v o l t l i g h t i n g . c o m
[email protected] • 813.978.3700
VOLT
®
LED All Star Tommy Light
Install Lamp
Install Faceplate and Glare Guard
2
3
Lamp
Set Screw
Socket
Faceplate
Glare Guard
Fixture
Install Fixture
4
Determine your desired location for
the fixture. Pass self-tapping screws
through the holes on the surface
mount. Thread self-tapping screws
into the wall surface to secure the
fixture.
NOTE: Wall anchors are required
for brick walls or concrete walls.
To determine locations for the wall
anchors, place the surface mount
onto your desired location and
mark the points from the holes in
the mount.
Fixture
Self-tapping Screw
Wall Anchors
Insert lamp with correct wattage
and type marked on fixture label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch lamp with
bare hands. Use soft cloth to
handle lamp.
Replace the faceplate over the
lamp and thread onto the fixture.
Tighten until snug. Attach the glare
guard back onto the faceplate and
secure with the set screw. Tighten
until snug with a screwdriver.
Wire Connections
5
Lay out the supply cable to the transformer. Strip both leads from the
luminaire pigtail. Connect leads from the supply cable to transformer
(sold separately).
Fixture
Pigtail
Transformer
(Sold Separately)
Supply Cable
