Volpi Tecno Energia PAGURO 3000 compact, Owner'S Manual

Page: 30 / 54

30
Note 2: Even if a small fuel filter is contained in the capsule, an external strainer and water
separator is suggested to delay the replacement time.
Starting battery connection
The PAGURO is negative grounded, and can be connected to the main board batteries 12 V or
to a separate small battery 12 V of about 60 Ah; in this second case its internal charging device takes
care of feeding the battery with 8 A
Note : In case of connection to the main board batteries the 8 A are available as well, but are not
enough to charge them: a static high power battery charger fed by the 230 V (115 V) of
the set must be present on board (on request).
Remote control (supplied)
It allows to start and stop the unit, to verify if there is a cooling or oil pressure failure, (in this
case the engine is shut-off automatically) and the power supplied control.
Note 1: The load indicator is designed for avoiding to overcharge the unit feeding too many
electrical loads; it begins to show the load after the first half power supplied and has to be
considered normal when the bar is green. The last red LED lighted means an overcharge:
switch-off the exceeding load to return at normal conditions.
Note 2: Do not forget the starter knob switched ON if the engine is not running for aborted starting
attempt (yellow LED blinking) because the engine shut-off valve remains energized and
takes useless power from the starting battery.
Note 3: If the yellow LED remains flashing when the set normally runs, it means that the internal
battery charger protection is shut-off, so the starting battery is no more loaded. In that
condition the automatic protection shut-off system is not operative, so
do not operate the
set with the yellow light flashing.
Reset the device pushing the button located on the grey box corner fitted on the set.
Note 4: If for operator’s mistake the starting knob is pushed whilst the engine is already running,
an electrical safety device avoids the gears reengagement, protecting the starting motor
preventing failures.