20 and 26 Inch Cheese Melters Operator’s Manual – Models JW1, JW2
3
CLEANING
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pads to clean the equipment. These can damage
the finish.
1. Press the On/Off switch to the OFF position.
2. Unplug the oven.
3. Let the oven cool completely.
4. Slightly dampen a soft cloth with a warm water.
5. Use the dampened cloth to clean the interior and exterior of the
oven, and the air intake on the side of the oven
6. Remove the shelf and clean with warm soapy water.
WARNING
Electrical Shock Hazard
Do not spray water or cleaning products. Liquid could contact
the electrical components and cause a short circuit or an
electrical shock.
CAUTION
Burn Hazard
Allow equipment to cool before moving or cleaning.
TROUBLESHOOTING
Problem
Might be Caused By
Course of Action
Oven does not heat.
Oven is not plugged in.
Plug in the oven.
The timer has not been set.
Set the timer. The timer must be set to turn on all the heater tubes.
The wall breaker may be tripped.
Reset the breaker.
The reset may be tripped.
Look at the side of the oven to see if an object is preventing the fan
blades from turning.
1. Press the On/Off switch to the OFF (O) position.
2. Unplug the oven.
3. Wait 30 minutes for the oven cool.
4. Remove the object.
5. Plug in the oven.
6. Press the On/Off switch to the ON (|) position.
7. Press the reset button.
8. If the problem persists call Vollrath Technical Services.
Inspect the fan blades to see if they are dirty.
1. Press the On/Off switch to the OFF (O) position.
2. Unplug the oven.
3. Wait 30 minutes for the oven cool.
4. Clean the fan blades.
5. Plug in the oven.
6. Press the On/Off switch to the ON (|) position.
7. Press the reset button.
8. If the problem persists call Vollrath Technical Services.
One or more heater tubes may have
burned out.
Contact Vollrath Technical Services.
There may be a problem with the heat
switch.
Oven repeatedly overheats.
The fan may be dirty.
Verify the fan blades are clean.
There may be a problem with the fan.
Run the oven for 10 minutes. If the fan does not run, contact
Vollrath Technical Services.
