1 of 2 | Dated 09.05.2016
GB Installation and Operating Instructions
LED candles
Art. No. 39005,39006,39007,39008,39009,39037,39038,39039,39048,39049,39103
These operating instructions refer exclusively to the above products.
They contain important information for the start-up and handling of the product.
Therefore pay attention to these operating instructions, even if you pass this product on to third
parties.
It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.
1. Introduction
Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of technology.
The product fulfils the requirements of effective European and national guidelines.
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!
2. Safety Instructions / Warnings
The guarantee becomes invalid if damage occurs due to the failure of following these operating
instructions!
We do not accept liability for any consequential damage!
Commissioning is strictly prohibited if there are any damages to the product!
The product in its entirety must not be altered or modified.
Alterations to the product invalidate the guarantee.
The type plate must not be removed.
3. Proper Use
The product is designed for use in indoor areas. It may
only be operated with batteries.
not be subjected to strong mechanical loads or heavy soiling.
4. Before Installation/Commissioning
The product must only be used outside its packaging.
Take the product carefully out of the packaging.
Make sure that the product has not been damaged during transport before taking it into operation. The
light may not be operated if there are any damages to electrical parts.
Keep packaging materials away from children and pets. Asphyxiation hazard!
5. Battery change
Set the switch to the "Off" position before changing the battery or inserting new batteries.
Open the battery compartment cover on the underside of the product and insert the batteries.
Pay attention to the correct polarity of batteries as shown in the housing (Size +/-).
Close the battery compartment after inserting the batteries.
Press the switch to turn on.
