11
REMOVING THE ACTIVEPURE
®
CELLS
CAUTION
Do not look directly at the glowing lamp. Prolonged exposure, even to reflected UV light, can
cause eye damage according to the American Conference of Governmental Industrial Hygienists
(ACGIH) Standards.
WARNING
• Unplug the unit before performing any maintenance procedures
• Do not operate the Vollara® Air & Surface Pro without the Filter Assembly and Back Cover
properly installed
NOTE:
Use genuine Vollara replacement parts only. Parts from anyone other than Vollara may damage your unit and void your
warranty.
1. Unlock the ActivePure
Cell connector by
pressing on the
connector’s locking tabs.
2. Pull the connector
straight out to unplug.
3. Remove two
(2) thumbscrews.
4. Slide the ActivePure
Cell down and out of
the unit.
INSTALLING THE ACTIVEPURE
®
CELLS
WARNING
• Unplug the unit before performing any maintenance procedures
• Do not operate the Vollara Air & Surface Pro without the Filter Assembly and Back Cover
properly installed
1. Slide the ActivePure Cell up and into
the unit. Be sure the back lip of the
ActivePure Cell engages the two
slotted protrusions at the rear of the
unit, and that the angle brackets
and studs are correctly aligned.
3. Press the connector firmly until
the two tabs lock into place.
5. Use the included screwdriver to
screw in the Filter Assembly.
6. Replace the Back Cover by
inserting the bottom in first
and snapping it into place.
2. Insert the two thumbscrews
and tighten. Insert the
ActivePure Cell connector into
the plug at the rear of the unit.
4. Replace the Filter Assembly,
inserting the bottom of the
Filter Assembly first.