12/29/2015
Bedienungsanleitung < Service & Zubehör < Volkswagen Deutschland
26/32
Select the memory that you wish to delete.
Press and hold the
button on the windscreen wiper lever, or the
button on the multifunction steering
wheel, for approximately 2 seconds.
Personal selection of displays
You can set which MFD display should appear in the instrument cluster using the
button and the
and
Multifunction display
function buttons in the infotainment system
→ Menu and system settings (SETUP)
.
Examples of display
Display
Function
Consumption
The current fuel consumption is displayed in litres/100 km while the vehicle is in motion, and in litres/hour while
the vehicle is stationary.
Av. consumption
The average fuel consumption will be shown after a distance of approximately 300 metres has been travelled.
The display will show dashes until this point. The displayed value is updated approximately every second.
Range
Approximate calculation of the distance in km that can still be travelled with the current fuel level under the
current driving conditions. One factor used for calculating this figure is the current level of fuel consumption.
Travel time
Driving time in hours (h) and minutes (min) that has elapsed since the ignition was switched on.
Distance
The distance travelled in km since the ignition was switched on.
Av. speed
The average speed will be shown after a distance of approximately 100 metres has been travelled. The display
will show dashes until this point. The displayed values will be updated approximately every 5 seconds.
Digital speed display
Current vehicle speed displayed digitally.
Speed warning --- km/h
or Warning at --- mph
If the saved speed (within the range of 30 km/h (18 mph) and 250 km/h (155 mph)) is exceeded, a signal tone
will be given, along with a visible warning if required.
Oil temp.
Current temperature of the engine oil displayed digitally.
Coolant
Current coolant temperature displayed digitally.
Saving a speed for the speed warning
Select display warning at --- km/h or Warning at --- mph.
Press the
button on the windscreen wiper lever, or the
button on the multifunction steering wheel to
save the current speed and activate the warning system.
If necessary, use the
rocker switch on the windscreen wiper lever, or the
or
buttons on the multifunction
steering wheel, within approximately 5 seconds to set the desired speed. Then press the
or
button again,
or wait a few seconds. The speed is now saved and the warning is activated.
To deactivate, press the
or
button. The stored speed will be deleted.
a)
Changes depending on the instrument cluster version.
Assist systems menu
First read and observe the introductory information and safety warnings
→
Introduction
Menu
Function
