– Clean connections on starter and earth strap between en-
gine and power unit. Do not disconnect earth strap from
power unit when doing this.
– Tighten connections after cleaning.
– Connect earth strap to battery.
– Operate ignition/starter switch.
If starter does not crank engine properly again, one of the fol-
lowing may be the cause:
◆
Insufficient contact between carbon brush and collector
– Check carbon brush for wear, and renew it as necessary.
◆
Collector is scored, burnt or soiled
– Renew rotor.
1.4
Removing and installing starter -B-
Special tools and workshop equipment required
◆
Torque wrench (5…50 Nm) -V.A.G 1331-
◆
Torque wrench (40…200 Nm) -V.A.G 1332-
Removing
.
Installing
1.4.1 Removing
Note
The procedure described below provides only general instruc-
tions for removing and installing the starter, since due to the
various use cases it is not possible to specify a common proce-
dure.
– Note safety precautions before beginning work
.
– Observe rules for cleanliness
.
– With ignition switched off, disconnect battery.
Industriemotoren - Industrial Engines 2009
▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
3
1 Starter -B-
469
