VolantexRC Racent EXA78502R, Manual

Page: 6 / 12

6 / 12
2. The receiver LED will turn solid.
3. To slowly drive forward, pull the throttle trigger slightly. Adjust the
speed by pulling the trigger. Push the trigger to brake/reverse. Release
the trigger to keep your vehicle still.
4. Rotate the wheel counter-clockwise to turn left. Rotate the wheel
clockwise to turn right.
6. If the direction of travel on the
rudder is opposite, slide the steering
reverse switch to the other position.
WARNING: Do NOT slide the throttle
reverse switch unless you completely
understand this function and it is
necessary to switch. Otherwise
serious damage may occur.
7. Adjust the servo angle by turning
the switch up or down.
Turn the switch to upper position for
larger servo angle.
Turn the switch to lower position for
smaller servo angle.
8. After you finished, turn off ESC
power, then unplug battery and put in
a dry safe place to cool down before
you use it again.
Running Tips:
1. Run your vehicle on a flat surface, and keep your vehicle in sight.
2. Always release the throttle trigger right away following a crash to prevent further damages.
3. Do not run your vehicle in an area with people or property nearby.
4. When you finish, always turn off your transmitter AFTER your vehicle power.
5. Always keep the battery unplug when you are not attempt to run the vehicle.
5. Use the steering trim dial to adjust the
neutral position of the servo.
Push the dial counter-clockwise to trim
left, clockwise to trim right, until your
vehicle tracks straight when steering at
neutral position.
Throttle Reverse Switcher
Steering Reverse
Switcher
Switch Up/Down for
Larger/Smaller Servo Angle
Steering Trim