The frame of the appliance will be warm during working by the defrost pipeline inside
it.
Please check the points above first.
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
4.
7
6
Heavy frost occurs on the rear of the appliance
Putting humid or hot food into the appliance may cause this problem. Or it may be
caused by heavy environment moisture.
Disgusting odour happens
Food with strong odour should be packed tightly before being put inside the appliance.
Please check whether there is any deteriorated item or whether the liners are left dirty
for a long time.
Water leaks from the bottom of the refrigerator
The drain tube is jammed. Please use a proper tool to solve it.
The follow cases are not malfunction
Moisture may form dew on the outside of the product during the
humid season, just
get it wiped.
The flow of refrigerant through the pipeline coil can cause a noise.
It is normal that the sides of product get warm as a result of the cooling pipeline
working.
5.
6.
7.
1.
2.
The compressor keeps working for a long period
The environment temperature may be too high. The doors may be opened frequently
or even they are left open. The temperature control knob setting in (4-7) state may
increase the working time of compressor.
4.
TROUBLESHOOTING TIPS
The refrigerator
work
It may not be connected to the power supply(plug, power cut or fuse); Voltage is too
low.
does not
The refrigerator does not work efficiently as expected
It may be caused by heavy frost, or by warm temperature setting,or by frequently
opening the door.
It is making an unusual noise
It may be caused by an imbalance please check all feet are of equal size and
the ground surface is flat .
1.
2.
3.
3.
Please get rid of the gasket of the door before the disposal.
The disposed apparatus should be handled by professional
staff, as it may be harmful to the environment.
Warning
INSTALL THE HANDLES
2. Prepare a cross screwdriver.
3. Make sure the three screw holes in the shake hands are aligned with those
in the door, and then respectively screw them together.
The right side one is suggested to be preferred to be screwed down.
1. Take out accessory from packing bags: two handles, two shake handle covers,
and six screws.
Handle Base
Handle Cover
Screw
Socket Head Wrench
4. Install handle cover on the handle.
Tips for the Steps to Install:
(1) Buckle the handle on the left side first.
(2) Buckle the handle on the left side.
(3) Buckle the middle part of the handle tightly in the end. And a click can be
heard if the handle is properly installed.
