PFW 6870
Installation Instructions
Page 11
Installing the Mounting Brackets (cont’d)
This section presumes that you have read and
understood thes
"Selecting the Proper Mounting
Hardware"
section.
1) Place your flat-panel screen-side down on a soft, flat
surface.
2) Identify the number and location of the thread
inserts on the back of your flat-panel.
3) Aligning the holes on each mounting bracket with
the thread inserts on the back of your flat-panel.
4) Secure each mounting bracket to your flat-panel by
inserting a minimum of two (2) screws per bracket.
Do not overtighten the mounting hardware.
Make sure the directional arrows on the mounting
brackets are facing up.
Attaching the Mounting Brackets to the Flat-Panel
Attaching the Flat-Panel to the Mount
Mounting the Flat-Panel
Mounting bracket adjustments are factory pre-set
(see
Note
).
This section requires two people.
Do not release your flat-panel until you are certain
that top and bottom hooks of both mounting
brackets are securely seated on the upper and
lower mounting rails of the wall panel.
1) Raise the flat-panel past the top and bottom
mounting rails on the wall panel.
2) Slide the flat-panel down slowly, keeping it close to
the wall.
3) Engage the top and bottom mounting brackets to
the rails of the mount.
Proceed to the “Mounting the Flat-Panel” below.
Note:
These registers
must align prior to
installation.They are
factory set. Check
to determine proper
alignment
