15
9.
PHONO/LINE switches
-
When inputing turntables to the PHONO/LINE 1 or 2 STEREO INPUT jacks,
use the accompanying switch. Select the out position to toggle to PHONO and the in position to toggle to
LINE input type.
10.
CD INPUT 1, 2, 3
-
Use these dedicated inputs for CD players as source music with RCA L/R
cables. Adjust the STEREO CHANNEL SOURCE toggle on the middle panel of the KJ-7800
accordingly.
11.
MICROPHONE INSERTS
- These jacks are for connecting out-board effects units. The audio from
the MIC channels are routed out from the INSERT jacks to your out-board effects unit(s) and routed back
with the effects applied, using only a single cable. In order to use these jacks, you will need appropriate
TRS (tip = send, ring = return, sleeve = signal ground) insert cables.
12.
VOLTAGE SELECTOR
- This switch can change the voltage from 115V to 230V. Before your KJ-
7800 Pro is shipped from the factory, the switch is set to 115V. If you live in an area that has different
voltage requirements (230-240V), you MUST set it to 230V.
13.
GROUND LIFT
switch - A “ground loop” is a phenomenon where an unintended connection to ground
is made through an interfering electrical conductor, causing what is known as “60Hz hum.” A GROUND
LIFT switch adds a resistor between the ground and cable shield when switched on, effectively ridding the
system of hum.
14.
GROUND TERMINALS
- These TERMINALS are for connecting ground wires. If you are experiencing
line noise, attach wire from here to your other devices or similar suitable surface.
15.
VIDEO OUT 1, 2, 3
- These jacks send graphics from input source player video output to video dis-
play device(s) such as TVs, TFTs and Monitors. Connect video cables from these VIDEO OUT jacks to the
VIDEO IN jacks on your video display device(s).
16.
VIDEO IN 1, 2, 3
- These jacks allow the video component of CD+G, DVD, VCD and LD players to be
connected to the KJ-7800 Pro. Connect video cables from the VIDEO OUT jacks on your player(s) to these
VIDEO IN jacks.
17.
REMOTE KEY CONTROL
- This 1/8” jack is for connecting a REMOTE KEY CONTROL cable. Remote
Key Control allows you to make key changes at a distance from the Digital Key Controller on the KJ-7800.
11
5
BOOTH OUT
MASTER OUT
REC OUT
remote
key control
VIDEO OUT
VIDEO IN
AV OUT
AV INPUT
STEREO INPUT
MICROPHONE INSERTS
1
2
3
4
PHONO
LINE
GND
GND
LIFT
AC INPUT
B
alanced
UNBAL
RECORD AUDIO
AV3
AV2
AV1
PHONO 3
CD 3
CD 2
CD 1
PHONO 2
LINE
PHONO 1
LINE
16
15
17
12
9
10
11
13
14
Rear Panel Descriptions
and Functions Cont...
