Setup each
SS-88
speaker stand by extending the support lefts to
a position that is stable and tighten the tension mechanism firmly.
Place a
VX-15
speaker on top of the
SS-88
so that the shaft of the
SS-88
fits flush into the mounting cavity on the bottom of the
VX-15
.
NOTE: Each end of the
SS-88
pole has a particular diameter fitted
for common speakers’ mounting cavities. If the
SS-88
shaft does
NOT fit flush into the mounting cavity on the
VX-15
, loosen the
SS-
88
pole and reverse it in the stand and then remount the speaker.
Repeat the above steps for each speaker and stand.
Be sure that each product has a power cord firmly attached. It is
recommended that you use a power strip/surge protector when con-
necting your
CLUB-8800
to a power outlet.
Connecting Power
Setting up the speakers and speaker stands
VX-15 Speaker
SS-88 Stand
Once you have mounted all of the components into the
CLUB-8800
, it is time
to connect them. Follow these directions on connecting the components.
NOTE: If you are also connecting components that are not part of the
CLUB-
8800
system, please refer to the manual of that product for setup instruc-
tions.
Connect the Control Interface Connector from the corresponding “CONNECT TO MAIN UNIT” jack on the rear panel of the
remote unit to the “CONNECT TO REMOTE CONTROL” jack on the rear panel of the player unit.
CDG-9000PRO remote unit to the player unit.
Connecting the components
CDG 9000 Player
CDG 9000 Controller
1
1.
2.
3.
MAKE SURE ALL PRODUCTS ARE POWERED OFF
PRIOR TO CONNECTING TO AN AC OUTLET.
