NETPREMISE
®
QUICK CONFIGURATION GUIDE
Hello! Thank you for Purchasing
NetPremise®
! We hope you enjoy using it as much we as had fun making it.
NetPremise
works best plugged directly to a wall socket
NOT
an Extension Box. Extension boxes damage the device.
NetPremise has two modes. Router or Extender Mode. By default,
Router Mode
is set-up. We recommend you change
both devices to
Extender Mode
in order to avoid IP conflicts on your network. Here are two methods of configuring your
NetPremise device to
Extender Mode
:
Configuring your NetPremise Device Wirelessly (Wi-Fi Setup)
Configuring your NetPremise Device via Ethernet Cable (Ethernet Setup)
Configuring your
NetPremise
®
Device Wirelessly (Wi-Fi Setup)
1.
Always ensure that
NetPremise
is plugged directly to a
WALL SOCKET
NOT
an Extension Box.
2.
After plugging the device to a wall socket, wait until the first indicator on the device changes from amber colour
to green. This indicates the device is ready.
3.
On your Wi-Fi enabled device (Phone, Tablet or PC), turn on Wi-Fi connectivity and search for available Wi-Fi
networks.
4.
Connect to the default SSID
“NETPREMISE”
by clicking on it and entering the default password
“12345678”
.
5.
On your device, go to your browser and type
“
http://192.168.1.10
”
and click Enter.
6.
Log in with the following default credentials:
Username:
admin
Password:
admin
7.
Upon successful login, a setup wizard will pop-up. Please
“Cancel”
the setup wizard and continue.
8.
Navigate to “
HiFy Setup
”
on the
LEFT PANE
of the menu and change setting to
'Hybrid Extender'
.
9.
Click
“Apply”
. A message will pop-up informing you that the IP will change to 192.168.1.254. Click
“OK”
10.
When NetPremise is in extender mode, its IP address automatically changes to
192.168.1.254
.
11.
The configuration is complete.
12.
At this point, the browser window will re-navigate you to the new IP address. This can take a while so it is
recommended you move to
STEP 14
to confirm the change
otherwise move to
STEP 15
.
13.
If you did a
Router IP address change
, please write down or memorize any new IP addresses and default
passwords.
14.
You can confirm its extender status by typing the IP address
http://192.168.1.254
in your browser address bar,
with the admin password in
STEP 6
.
15.
Unplug that device; plug in the next NetPremise device and repeat steps 2-11.
16.
Clicking “
HiFy Setup
”
on the
LEFT PANE
of the menu will show
'Hybrid Extender'
to be the default.
17.
Click
“Logout”
to logout of the device.
