9
Checking the state of the batteries in the ejector
The state of the batteries is checked by flashing indicators on the bottom side of the
ejector.
Charged battery
– the green indicator flashes when the ejector is switched on.
Low battery
– the green and red indicator flashes simultaneously when the ejector
is switched on.
If the batteries are discharged, insert new alkaline AA batteries into the ejector.
Switching ON/OFF
To switch on/off the ejector, a magnetic switching system is used. The system is
activated by attaching a magnet. The magnet is attached at the bottom part of the
transmitter.
Switching on:
1.
Attach the bottom part of the transmitter to the red round target on the bottom side
of the ejector – the red indicator and then the green indicator will turn on.
2.
Take the transmitter away from the ejector when the green indicator is on. The green
indicator will start flashing.
Switching off:
1.
Attach again the bottom part of the transmitter to the red round target on the
bottom side of the ejector – the green indicator and then the red indicator will turn
on.
2.
Take the transmitter away from the ejector when the red indicator is on. The
indicators will stop flashing.
Important:
When switching on the ejector, it is enough to attach the transmitter to
the red target of the ejector for approximately 1 second. If you hold the transmitter
at the target for more than 5 seconds, the receiver enters the mode of pairing
the transmitter with the ejector. If this happens, follow the chapter
“Pairing the
transmitter with the ejector”
on pg.10
.
CAUTION:
To extend the
battery life, the ball feeder
must always be turned
off after training. We
recommend removing the
battery completely if you
do not use the ball feeder
for a long time.
Summary of Contents for Dog Trace d-ball UP
Page 1: ...ELECTRONIC BALL EJECTOR User guide EN ...
Page 15: ...15 ...
