Step 7
Mark the ceiling or desired mounting surface in preparation of in-
stallation of ceiling plate . If mounting to wooden ceiling joists,
pre drill pilot holes using a 7/32” drill bit. Attach the ceiling plate
to the wooden ceiling joist using the 5/16” by 2.5” long lag
screw and washer . WARNING: Please verify that your
mounting surface will support the combined weight of your mount,
mounting hardware, and fl at panel. Also verify that the mounting
surface is safe to drill through. Please note only mounting hardware
for mounting to wooden ceiling joists will be provided with the unit.
If mounting to a surface other than wooden ceiling joists then other
hardware will be required. If in doubt or uncertain about any of the
above, please contact a professional installer.
Step 8
Attach the other feed through coupler to the top of the upper
plate using the shorter socket screws and washers .
Step 9
Screw the extension outer tube into the feed through couple
on the ceiling plate . Screw the extension inner tube
into the feed through couple on the upper plate . Tighten
brake screws into the threaded holes in the feed through
couples to secure the extension tubes in place. To adjust the
drop length of the mast, remove the 5/16” screw and slide the
inner tube so one of the other holes in the inner tube line up with
the holes in the outer tube. Then reinsert the 5/16” screw and
retighten the nylon nut .
Step 10
To adjust the tilt or pan of the projector, simply drag the projec-
tor to the desired position. If you have diffi culty doing so, slightly
loosen the short socket screws that are in the plastic bushing
until desired tension is achieved to make tilting or panning eas-
ier. Cables may be ran through the center of the mount and the
ceiling mast either by using the holes in the feed though couplers
or the holes in the center of the mount and ceiling plate. Please
verify that all nuts and screws are securely tightened.
Step 7: Attaching the ceiling
plate to the ceiling
Step 8: Attaching the feed
through couple to the mount
Step 9: Connecting the mount
to the ceiling plate
WARNING: The installer of these products must verify that
the mounting surface, ceiling or wall, will safely support the
combined weight of all attached equipment and hardware.
Video Mount Products will not be held liable for the improper
use or installation of its products.
Enjoy Your Mount!
25
18
1
7
5
1
15
6
7
4
17
4
14
4
14
19
Step 10: Post installation
adjustment
17
1
26
27
