Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount.
Step 2
Determine the VESA standard that your TV follows to determine
which VESA plate you will be using. For VESA 75 or 100 use the
small mounting plate and for VESA 200 or 100x200 use the large
mounting plate . Once you have determined the correct VESA
plate for your TV, attach the plate or
#6)
to the pivot bracket
(#4)
using an M6 screw
(#9)
and nylon nut
(#7)
.
Step 3
Attach the swivel bracket
(#4)
to the support tube
(#3)
using the
3/8” screw
(#16)
, washers
(#15)
and nylon nut
(#8)
. Insert the ad-
justing screw
(#12)
into the back of the pivot bracket
(#4)
for use
when tilting the monitor.
If you plan to use the ceiling mast:
Step 4
Mark the ceiling or desired mounting surface in preparation of in-
stallation of ceiling plate
(#1)
. If mounting to wooden ceiling joists,
pre drill pilot holes using a 7/32” drill bit. Attach the ceiling plate
(#1)
to the wooden ceiling joist using the 5/16” by 2.5” long lag
screw
(#43)
and washer
(#44)
. WARNING: Please verify that your
mounting surface will support the combined weight of your mount,
mounting hardware, and fl at panel. Also verify that the mounting
surface is safe to drill through. Please note only mounting hardware
for mounting to wooden ceiling joists will be provided with the unit.
If mounting to a surface other than wooden ceiling joists then other
hardware will be required. If in doubt or uncertain about any of the
above, please contact a professional installer.
Step 5
Attach the extension tube
(#2)
to the
support tube
(#3)
using the ¾” bolt
(#10)
and washers
(#11)
. Then screw
the longer ¼” brake screw
(#17)
into
the extension tube
(#2)
so that it is
tight against the ¾” bolt
(#10)
. This will
prevent the ¾” bolt
(#10)
from turning
loose within the extension tube
(#2)
.
Step 2 : Selecting the correct
mounting plate
Step 3: Attaching the pivot bracket
Step 5(Right) : Attaching the
extension tube
Step 4: Mounting the ceiling plate
2
15
6
5
3
16
6
5
4
7
9
3
4
12
8
4
1
1
44
43
10
11
17
2
10
10
2