Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount.
Step 2
Determine which VESA standard plate you will be using or
)
(75mm/100mm or 200mm/100mmx200mm respectively) and at-
tach the selected mounting plate or to the swivel bracket
using the M6 screw and the nylon nut .
Step 3
Attach the swivel bracket to the support tube using the
3/8” screw , washers and nylon nut . Insert adjust-
able screw into the back of the swivel bracket for use
when tilting the monitor.
Step 4
Mark the ceiling or desired mounting surface in preparation of in-
stallation of ceiling plate . If mounting to wooden ceiling joists,
pre drill pilot holes using a 7/32” drill bit. Attach the ceiling plate
to the wooden ceiling joist using the 5/16” by 2.5” long lag
screw and washer . WARNING: Please verify that your
mounting surface will support the combined weight of your mount,
mounting hardware, and fl at panel. Also verify that the mounting
surface is safe to drill through. Please note only mounting hardware
for mounting to wooden ceiling joists will be provided with the unit.
If mounting to a surface other than wooden ceiling joists then other
hardware will be required. If in doubt or uncertain about any of the
above, please contact a professional installer.
Step 2: Attaching the mounting
plate to the swivel bracket (small
mounting plate (#5) shown)
Step 3: Attaching the swivel
bracket to the support tube
Step 4: Attaching ceiling plate
to ceiling
3
1
12
16
5
9
8
7
4
1
6
23
24
15
5
6
4
4