3
Please read this manual carefully. It contains important information about installation,
use and maintenance.
Warning
1.
Safety Instruction
Please read this instruction carefully before using this product.
。
Please keep this manual as a reference for future consultation
，
If you sell this product to other
users, please make sure they also get this manual.
Please use it correctly on the basis of full understanding of the content.
Notice
：
The equipment is packed in good condition when leaving the factory. Please operate it according
to the user's manual. The machine failure caused by human factors is not covered by the warranty.
Before using the product, please open it and check carefully,to ensure that there is no damage
caused by transportation.
This fixture is only suitable for indoor dry places.
The installation and operation of the fixture,should be carried out by professionals.
Do not let children operate the fixture.
Use secure ropes when fixing the device, and hold the bottom at the same time when moving the fixture.
The equipment must be installed in a well-ventilated place, at least 50 cm away
from the adjacent surface.
Make sure the ventilation holes are clear to avoid overheating when the fixture is running.
Before operation, make sure that the power supply voltage matches the power supply voltage required
by the fixture.
Please ground the conductor to prevent electric shock.
Ambient temperature: Do not operate the fixture below -25°C or above 45°C.
It is forbidden to connect the fixture directly to the dimming equipment.
Do not place combustible materials within 1 meter of the fixture When it is running, , to avoid fire hazard.
Please carefully check whether the power cable is damaged before turning on the
fixture, and replace it immediately if there is any damage.
The surface temperature of the fixture can reach 55
℃
during operation, please do not touch it
with bare hands.
Avoid operating in dirty and dusty environments, and clean and maintain the fixture regularly.
It is forbidden to touch the wire when the fixture is running to prevent electric shock.
Avoid entanglement of the power cable and other wires
The distance between the fixture and the illuminated surface should be greater than 15M
。
Disconnect the power supply before replacing the fuse or bulb.
