3. Add coffee powder into filter. Usually a cup of coffee
need a level spoon of coffee powder, but you may adjust
according to personal taste. Then close the top lid.
4.Place the carafe on the keeping warm plate.
5. Plug the power cord into the outlet. The LCD will
display “AM12:00” and the colon will flash.
6. Press on/auto/off button once, the indicator in it will be
illuminated red. The appliance will begin working.
7. The brewing process can be interrupted by pressing
the on/auto/off button twice at any time during operation,
and the indicator in it will be illuminated blue, after about
15s, it will be extinguished. The appliance will continue
brewing once on/auto/off is pressed again.
Note: You can take out the jug, pour and serve at any
time. The appliance will stop dripping automatically. But
the time cannot exceed 30 seconds.
8. Remove out carafe to serve when finish brewing
(about one minute later after the coffee stops dripping
out.)
Note: the coffee you get will less than the water you have
added, as some water is absorbed by coffee ground.
9. When the process is finished, if you do not want to
serve immediately, keep the coffee maker is energized,
the coffee can be kept warm in the keeping warm plate.
The appliance will be cut off power automatically after
two hours if it has not been manually disconnected at the
completion of brewing. For an optimum coffee taste,
serve it just after brewing.
10. Always turn the coffee maker off and disconnect the
power supply when not use.
Caution: When pour coffee, the momentary inclined
angle of carafe shall not be more than 45 degree from
the vertical position, you shall pour the coffee slowly until
the carafe is empty, otherwise the coffee in the carafe will
rush to the bottom of carafe lid, and the coffee will flow
out from two edges of lid and hurt person!
NOTE: Holding TIME for 3 seconds will speed the time
up. Holding for 10 seconds will speed it up again.
The clock is now set!
To Set the Delay Brew Time:
After setting the clock, simply press the PROG button
twice (TIMER appears)
and set the brew time by pressing and holding the TIME
button. The AM/PM indicator
will light up on the clock display.
The Delay Brew Time is now set!
Setting the clock and delay brew time
On programmable models only
To Set the Clock:
1 Plug the power cord into a standard
electrical outlet.
2 Press the PROG button and the word
CLOCK appears. Press and hold the
TIME button until you reach the current
time. The AM/PM indicator will light on
the left of the display.
AUTOMATIC START FUNCTION
(Figure 1),
(Figure 1)
