11
Support shaft height setup
1.
General info
Usability of pedals is provided by support shaft height. You must rotate sincronizers
to set up this height. The height of both shafts in neutral rudder position must be the
same.
2.
Order of setup
To set up support shaft height, execute the following operations.
1. Unclench syncronizer springs, turning off compressing nuts by included wrench
(fig. 2.1).
2.1. маю
2. Rotate ribbed tube of the syncronizer to set appropriate support shaft height.
3. Ensure that the height is in acceptance limits.
3.1. Pull down support shaft till it touches the foreleg damper.
3.2. Look at the frame in the case (fig. 2.2). The gap between the body of the spring
loaded screw and frame edge must be at least some millimeters.
2.2.
Fig. 2.1.
Do not install support shaft too high! In this case the parts of pedals construction
will be loaded too much and can be destroyed. Rotating ribbed tube do not unscrew
threaded rod end of the bearings from it!
