RF grouping
2. Press button “Ambient”, the surrounding lux level is sampled and set as the new daylight threshold.
Ambient daylight threshold
Dual tech & RF mode
Hold-time
Stand-by dimming level
Stand-by time (corridor function)
Press buttons in zone “hold-time” to set the hold-time at 2s / 30s / 1min / 5min / 10min / 15min / 20min / 30min.
2. 2s is for testing purpose only, stand-by period and daylight sensor settings are disabled in this mode.
*To exit from Test mode, press button “RESET” or any button in “Hold-time”.
Press buttons in zone “stand-by time” to set the stand-by period at 0s / 10s / 1min / 5min / 10min / 30min / 1h / +∞.
motion detected, and remains at the stand-by dimming level after motion hold-time.
Press the button in zone “stand-by dimming level” to set the stand-by dimming level at 10% / 20% / 30% / 50%.
“HF”,”PIR”, “HF+PIR”, “HF/PIR” are disabled.
For RF grouping via remote control, please refer to steps below:
Short press “Learn/Erase” button on RC to activate pairing mode, and the
receiver unit starts to beep once every second for 3min.
Note: the unit can only pair up to 30 units.
Step
1
The receiver unit (slave)
Beeper is on for 3min
Short press “Learn
/Erase” button
Step
3
The receiver unit (slave)
Beeper is on
Erase:
Long press “Learn/Erase” button for 3s to the sensor unit. The beeper
beeps rapidly for about 5s. All commands received before are erased.
Step
2
The transmitter unit (master)
The beeper beeps one time
Beeper beeps rapidly
when RF signal is received
Short press “Transmit” button on RC, the commander unit (master unit)
beeps one time to send the transmission signal.
Upon receiving the transmission signal, the receiver unit (slave unit) rapidly
beeps 3 times in 1s to indicate the success of pairing. Repeat this
step to pair more units.
One more short press on “Learn/Erase” button to the receiver unit to
complete the pairing process, the receiver unit will quit the pairing mode.
Note: Press button RX100%, the light on receiver unit is 100% on upon receiving
RF on signal; Press “RX STBY%” button, the light(s) goes to preset stand-by
dimming level directly.
The receiver unit (slave)
Short press “Transmit” button
Short press “Learn
/Erase” button to
quit pairing mode.
All buttons in this zone are disabled.
7/8