6. Remove the panel located above the bumper inside the back of
the vehicle.
7. Drill a
1
⁄
2
” hole under the center of
the panel for routing the wire in
the vehicle. (Fig. 2)
8. Route the cable to the location
(i.e. under the seat or in the panel).
A/V Control Module Installation
1. Locate suitable A/V Control Module mounting location
(i.e. center console).
2. Attach the A/V Control Module wires as follows:
Wire Color
Connection
1. Red
+12V Battery
2. Orange
+12V Reverse Light
3. Black
Ground
3. Secure the A/V Control Module using the provided screws.
Package Contents & System Diagram
• 3.5˝ LCD Monitor w/Mirror Mode Display
• Color CCD Bullet-Type Camera w/Cable
• Angled Controller Rings (3 sizes)
• Fixing Rings
• A/V Control Module
• Monitor Cable
Camera Installation
1. Locate a suitable camera mounting location on the Car Body
(i.e. center of the rear bumper). (Fig. 1)
2. Drill a 1-
1
⁄
8
˝ diameter hole at that location.
3. Attach the desired Angled Controller Ring to the Camera
Body before installing.
4. Insert the Camera Body through the car body and attach the match-
ing Angle Controller Ring and spacer to the Camera Body.
5. Secure the Fixing Rings to the threaded portion of the Camera Body
locking the camera in place.
A/V Control
Module
LCD
Monitor
+12V
Battery
Ground
+12V
Reverse light
CCD
Camera
Fig. 1
Fig. 2
