LCD Monitor &
CCD Color Camera
Hummer
H2–2003-2004
Installation Manual
1493 Bentley Drive • Corona, CA 92879 • 909-272-1996 • 800-624-7960 • Fax 909-272-1584
www.vizualogic.com
Copyright © 2003 TMI Products, Inc.
All Rights Reserved
Corona, CA U.S.A.
060300
99-8019-002 10/03
Backup Monitor System
Backup Monitor System
Fall 2003
Monitor Installation
1. Locate the center console on the front part of the headliner.
2. Remove the (2) Phillips screws from the center console and slide
towards the front of the vehicle.
3. Insert the monitor cable through the opening in the headliner
and route to the A-pillar.
4. Pop out the (2) clips holding the handle to the driver side A-pillar.
(Fig.2)
5. Remove the handle and plastic shroud A-pillar.
6. Route the monitor cable from the headliner to the A/V Control
Module located under the seat or alternate location.
7. Insert the Monitor Cable into the opening on the backside of the
Monitor Housing.
8. Connect the Monitor Cable to the LCD Monitor.
9. Screw the LCD Monitor onto the Monitor Housing using the (2)
provided screws.
10. Secure the rear-hooks of the Monitor housing to the top of the
console. (Fig. 3)
Fig. 1
Fig. 2
Fig. 3
