a. At the back of the seat, grip the bottom edge of
the upholstery and pull down and back to
unclip the “J” clip from the seat frame.
seatback Installation
1. Remove factory front seat upholstery and foam.
(NOTE: Take care not to damage the factory upholstery.)
b. Unclip the “J” clip that attaches the front and
back of the seat upholstery and pull the plastic
panel out of the back of the seat.
c. Pull the upholstery up from the bottom, turning
it “inside-out” as you progress.
d. Use diagonal cutters to Cut (3) hog rings at
front of seat at base of “headrest” section
of seat.
e. Lift seat upholstery off of seatback
foam and remove seatback foam from
seat frame.
Monitor Installation
3. Install VizuaLogic Monitor
3
a. Ensure the upholstery trim template is still
properly positioned in the plastic bucket by
pressing against the seat back and carefully
adjusting its position to ensure no overlap
between the edge of the template and the edge
of the bucket.
b. With a sharp razor blade or hobby knife, start a
cut near the center of the template opening.
Being careful not to cut past the inner edge of
the template, cut away from the center of the
bucket. Once you have contacted the inner edge
of the trim template, cut all the way around the
inner edge of the template and each of the four
1/4˝ slits, one along each side.
c. Remove the upholstery trim template from
inside the seat cover.
d. With the excess upholstery trimmed away, fold
each flap into the bucket and place each slit
onto the corresponding “arrowhead shaped”
tabs in the bucket walls.
e. Install the (4) christmas tree clips
into the screen bucket from the
inside out. These clips will hold the
screen bucket into the foam bucket.
6
