15
Installation and Connections
Failure to make the proper c onnec tions may
res ult in fire or produc t damage.
(C hec k with your dealer if you are not s ure.) Failure
to do s o may res ult in elec tric s hoc k or injury due to
elec tric al s horts .
Warning
Make the correct connections.
Use only in cars with A 12 volt negative ground.
Do not allow cables to become entangled in
surrounding objects.
Be sure to disconnect the cable from the (-)
battery post before installing this unit.
Be sure to connect the color coded leads
according to the diagram.
When making connections to the vehicle’s
electrical system, be aware of the factory
installed components. Do not tap into these leads
to provide power for this unit.
This unit uses female RCA-type jacks for
connection to other units (e.g. amplifier) having
RCA connectors.
Arrange wiring and c ables in c omplianc e with the
manual to prevent obs truc tions when driving.
This will reduc e any c hanc e of damage to the unit in
c as e of a s hort-c irc uit.
Inc orrec t c onnec tions may c aus e the unit to
malfunc tion or damage to the vehic le's elec tric al
s ys tem.
Failure to do s o may res ult in damage to the unit or
vehic le. When it doubt, pleas e c ons ult your dealer.
You may need an adaptor to c onnec t other units . If
s o, pleas e c ontac t your authorized dealer for
as s is tanc e.
Never c ut away c able ins ulation to s upply power to
other equipment. Doing s o will exc eed the c urrent
c arrying c apac ity of the wire and res ult in fire or
elec tric s hoc k.
When drilling holes in the c ons ole box for
ins tallation, takes prec autions s o as not to c ontac t,
damage the elec tric al wiring. Failure to take s uc h
prec autions may res ult in fire.
S wallowing them may res ult in s erious injury.
If s wallowed, c ons ult a phys ic ian immediately.
Do not splice into electrical cables.
Do not damage the electrical wire when drilling
holes.
Keep small objects as batteries out of the
reach of small children.
Precautions:
B efore ins talling or c onnec ting the unit, pleas e read
the following and page 2~ 3 of this manual
thoroughly for proper us e.
The bac k s eat pas s enger mus t fasten the safety belt
before operating the unit.
The c hink between the front s eat and c enter c ons ole
box mus t be greater than the thic knes s of the brac ket
arms
.
The top c over of the C enter c ons ole box s hould be
operated. We propos e that the trans vers e axle mus t
be higher than the top c over by
.
B oth s ides of the brac kets s hould not go beyond the
c as e edge of C enter c ons ole box and too near to driver.
The wiring and ins tallation of this unit requires
s pec ial tec hnic al s kill and experienc e. To ens ure
s afety, always c ontac t the dealer where you
purc has ed this unit to have the work done.
B e s ure to us e only the s pec ified ac c es s ory parts .
Us e of other than des ignated parts may damage this
unit internally or may not s ec urely ins tall the unit in
plac e. This may c aus e parts to bec ome loos e
res ulting in hazards or produc t failure.
Caution
Limitation
Have the wiring and installation done by experts.
Use specified accessory parts and install them
securely.
greater that the width of the monitor.
LCD Monitor 22cm
(At least 1.5cm)
3-5 cm
8”
Arrange the wiring so it is not crimped or
pinched by a sharp metal edge.
Drilling can cause airborne debris.
R oute the c ables and wiring away from moving parts
(like the s eat rails ), s harp or pointed edges . This will
prevent c rimping and damage to the wiring. If
wiring pas s es through a hole in metal, us e a rubber
grommet to prevent the wires ins ulation from being
c ut by the metal edge of the hole.
Airborne debris c an c aus e s erious injury to the eyes .
Wear protec tive eye-wear when drilling.
The width between the front seats must be
C enter Armres t Monitor
