2
107 mm
1
3
3
- Put two marks on a wall with the center
to center distance 107 mm between
them. You may use the pattern given
here on the right.
Drill two holes (1) in the wall with 6 mm
in diameter and 40 mm depth.
- Drive nylon anchors (2) into the holes
and fasten screws
in the
anchors (fasteners are supplied).
3.5х22 (3)
- Hook the base on the screws, and hang it ( ) on the wall.
Set the ring volume slide switch
to select
the comfortable ring volume:
Hang up the handset (
) on the base.
9
-
(10)
-
11
position
sets the
ring volume;
position
sets the
ring volume.
The switch’s position also influences the volume
of intercom.
-
0
I
minimum
maximum
-
(4)
(5)
-
Connect doorphone wires
to the terminals
on the base’s back
following the diagrams
given in the section
Observe polarity of wires.
Lay the wires in the recess
, and then lead
them along the groove
EXAMPLES OF WIRING
DIAGRAMS
.
(6)
(7).
-
(8)
-
Set the jumper
to one of the
following positions:
- if an additional handset is connected;
-
- if there is no additional handset.
EQV. UKP
UKP
EQV
4
9
11
INSTALLATION
Note
:
(12)
Button
is intended for door lock release.
The button releases the door lock only after intercom
has been engaged.
10
12
107 mm
6
5
4
7
8
www.
5
UKP-12-1 Operating Instruction (revision
12)
vizit-group.com
2 3
/
201 -
