Page
1
SOLAR POWERED DUAL PURPOSE OUTDOOR LED WALL LIGHT
THANK YOU!
Vizionary Products would like to thank you for purchasing
this quality product through Amazon. Once you have enjoyed
using it, we would greatly appreciate it if you could take the
trouble to post a review of this product on Amazon.
The following instructions describe the correct operating
method to ensure prolonged service life. Please familiarize
yourself with these instructions before operating your solar light.
We suggest you keep these instructions for future reference.
INTRODUCTION
This type of light uses solar power and lithium ion battery
technology, and is ideal for entranceways, walkways, carports
and other areas where electricity is not available or wiring is
not desired.
During the day, the solar panel at the
top of
the unit will
charge the battery inside. At dusk, one LED (light emitting
diode) will activate automatically using the stored energy from
the sun to provide a constant, warm, effective yet unobtrusive
light. If, at any time, motion is detected by the PIR (Passive
InfraRed sensor) a second, brighter LED will activate for your
safety, security and convenience.
PASSIVE INFRARED (PIR) MOTION SENSOR
This sensor has a range of up to 5 meters with a 90
0
detection range,
both vertically and horizontally (see Figure 1).
POSITIONING YOUR SOLAR LIGHT(S)
•
Your solar light includes a built-in photo sensor, which
detects the level of surrounding light and controls when
your light will switch on and off. If you wish to install more
than one solar light, place them at least 1.5 meters apart.
They should also be mounted away from other nighttime
light sources that could prevent the solar lights from
turning on automatically at dusk.
•
Ideally, you should locate your solar light in an area where it will
receive the maximum daily amount of direct sunlight.
•
To charge the battery fully your solar light should be exposed to
at
least 4,5
hours of direct sunlight each day
. Shady locations
may not allow the battery to charge fully and may reduce
the number of hours of nighttime light provided.
•
You will no doubt appreciate that
the performance of your
solar light is also dependent on your geographical location,
weather conditions and season.
On cloudy days and during
winter, your solar light will receive less direct sunlight and this
may result in reduced operating time and brightness.
•
When choosing a suitable location for your solar light,
remember that the PIR sensor detects an area of
approximately 90 degrees both horizontally and vertically,
within a range of up to 5 meters (see figure 1).
•
The recommended mounting height for your solar light is
approximately 1.6 meters but this will depend on your
application.
ASSEMBLY & INSTALLATION (Figure 2)
This pack should come complete with the following:
1 x solar wall light with PIR sensor (Part A)
1 x fastening screw (Part B)
1 x plastic wall anchor (Part C)
To install your solar light, please follow the steps below:
Step 1:
Locate a wall or vertical surface where you wish to
mount your light:
•
Before securing the light to the wall or surface, it is
recommended that you first check the light effect at night to be
sure you are completely happy with the position you have
chosen, for both the lighting effect and the PIR sensor range.
•
It is also important to remember that lights should be installed in
a location that will receive sufficient direct sunlight each day.
CONCRETE / MASONRY SURFACE INSTALLATION
Step 2:
Drill a hole into the surface suitable to accommodate
the plastic anchor (C) snugly. Then insert the anchor into
the hole.
