Trunk boxes and an aerated cage are in the front cockpit. A box for spinning rods and side niche
areas for various small things are in the aft cockpit. Fuel tank compartment, battery box and a trunk
box for various things are on the back platform. The lids of trunk boxes and floorboards are made of
water resistant laminated plywood (12 mm thick) with nonskid surface.
4. 1
BASIC HULL PARAMETERS
-
bottom plating
,
transom
– 3
mm;
-
sides plating
– 2
mm;
-
longitudinal and transverse frames
– 3
mm;
-
water gripping sponsons
–
angle
50
mm
x
30
mm
x
3
mm
;
- stringers – U-bar 30 mm х 50 mm х 30 mm х 3 mm.
Behind the aft bulkhead there is a self-draining submotor recess; steering rope (in the console
construction) and
outboard motor control wires and cables (not included into the delivery set) are
connected to the recess through grease-retainers.
A drain hole with a caprolon plug is installed on the back of the boat, in the bottom part of the
transom. Drain hole is meant to drain the water leftovers when bringing the boat ashore.
5. STEERING AND POWER SYSTEMS
An outbard motor (not included into the delivery set) with power allowance not more than 50 HP is
to be installed on the boat. In its console construction the installation of an outboard motor
controller is to be performed on the right side behind the console. In the rudder construction the
boat is operated with the help of an outboard motor rudder, in the console construction – by means
of remote steering control which includes
:
-
steering gear
;
-
steering wheel
;
-
wheel rope with rigid housing (12 ft in length).
ENG
8
