STEP 3A - MOUNTING TO A WALL WITH WOOD STUDS
The mount can be attached to walls with wood studs. The wall
covering (drywall, lath, plaster, etc.) may not be thicker than 1/2”.
If you are mounting on a concrete wall, go to Step 3B on page 6.
1. Use the electronic stud finder to locate two studs in the wall.
The studs should be approximately 16” apart. Use the pencil to
mark the areas of the wall where the studs are located.
2. Hold the mount against the wall, using the pencil marks as a
guide. Ensure the slots in the mount line up with the studs.
Use the built-in level to level the mount.
When the mount is level, hold it in place and use the pencil to
mark the areas inside the slots where bolt holes will be drilled.
Ensure the marks you make are over the studs.
1
2
Ensure slots in
mount line up
with studs
Built-In Level
16”
Instead of holding the mount against the wall, you can use
the included template. Please note: To level the template,
you will need a level (not included).
4
