SETTING UP
Ball head
Camera
mounting
block
Turn the camera mounting block
while pushing the 1/4” thread screw
Ball head
Camera
mounting
block
Turn the camera mounting block
while pushing the 1/4” thread screw
Attach another ball head adapter to the camera mounting block.
Push the 1/4” thread screw protruding from the center on the
underside of the camera mounting block so that the 1/4” thread screw
is pushed out on front side. Attach the ball head adapter on the
camera mounting block with the protruded 1/4” thread screw and fix it
securely by turning the camera mounting block as shown in the figure.
Attach the camera onto the ball head-mounted Polarie. Make sure
that the camera is installed securely on the ball head adapter with the
camera mounting dial fully tightened.
Hold with the hand secrely
Camera
mounting dial
Ball head
Finish
Camera
mounting dial
Camera mounting block
1/4” thread
screw
Push
Make sure that all the locks are
fastened fully
Hold with the hand secrely
Camera
mounting dial
Ball head
Lock lever
Lock lever
Camera
mounting dial
Make sure that all the locks are
fastened fully
Put the camera mounting block
back on the Polarie and fix it securely
with the two thumb screws.
Note: Be sure to securely hold the
camera with your hand while
attaching it to avoid dropping the
camera from the ball head adapter.
Also, make sure that all the screws
and lock levers are fastened fully.
Losing balance due to unlocked
levers could damage the camera or
lead to injury.
4
6
5
Camera mounting block
1/4” thread
screw
Push
Thumb screw
Thumb screw
Thumb screw
Thumb screw
Thumb screw
Thumb screw
12
