VXH1004
INSTALLATION GUIDE
PAGE 2 of 2
PULL LEVER MOUNTING
Find a proper location near the driver seat and install the pull control lever using two self-tapping screws (not
provided).
Run the pull control wire trough the dashboard to the engine compartment and connect the wire to the switch
lever on the horn. Do not bend or twist the wire during this process.
ADJUSTING THE PULL LEVER
Place the control lever in the stand-by position.
Release lever clamp screw, pull out the wire
tube and cut it to a suitable length. (Do not
detach the wire from the control lever).
Install the tube again and affix the lever clamp
screw.
Tighten the horn clamp screws, keeping the
wire a length of four centimeters past the end
of the tube.
Affix the end of the wire to the switch lever and
tighten the horn clamp screws again.
ADJUSTING VOLUME
Release the horn clamp screws and move it
upwards for higher volume. When the desired
volume is reached, tighten the horn clamp
screws again.
ELECTRICAL CONNECTIONS
Using a 20A inline fuse (not provided), connect the positive wire (RED/WHITE) to the (+) 12-volt positive
power source of your vehicle, such as, the battery, alternator, accessories, etc.
If the horn's bracket was not grounded during the mounting process, find a 16 gauge electric wire and attach
it to one of the mounting bracket screws. Make sure to tighten the screw with the stripped wire end to the
surface. Connect the other stripped end of the electric wire to any metal surface on your vehicle that is clean
of paint and rust.
