Vix 88 762 57, Manual, Page: 6 / 11

10 11
• Set the machine to standby with the power switch on the left side
of the grip. The machine is in standby when the LED glows red.
• Open the cover to the wire chamber by pressing the open switch
on the back of the grip and install the wire coil (88 76 258) into the
chamber.
• Pull out and straighten approx. 10-15cm of the wire and insert
it into the machine as far as possible. With two fingers, keep
a gentle push into the machine and push the trigger button.
WARNING: Keep your fingers clear from the jaw (see picture 2).
How to tie:
• Put the jaw of the tying machine around the rebar and the
cable at a 45 degree angle.
• Press the trigger button to activate the tying process.
•
When the automatic tying process is finished lift the jaw from
the tying point and pull the machine away.
• The jaw of the tying machine may be
adjusted if necessary with the hex screw on
the jaw (see picture 2).
Operation manual:
Make sure to fully charge the machine before first use. The
battery is fully charged when the LED glows green.
About this product:
The heating cable tying machine from
Vix is specifically designed to tie heating
cables and pipes to rebarsat a fast
pace and with adjustable tying strength
(adjusted from 1-10 by use of the
+/- buttons on top of the machine. (See
picture 1).
Only use the machine with the
designated tying wire (88 76 258) from
Vix.
Picture 1
Picture 2