VIVOTEK
62 - User's Manual
WPS:
ADSL/Cabl
e/Hub
12V
1.5A
ETHERNE
T
WPS
1. Make sure your AP (Access Point) and Operating System support WPS (Wi-Fi Protected Setup)
functions. WPS enables easy setup with compatible APs.
3. The camera's blue LED should start flashing. Press and hold down both of the WPS buttons on
your AP and your camera for at least 1 second. (Some router/AP will have a virtual button on their
management software instead.) Refer to your AP's documentation for details using its WPS function.
If your AP does not support WPS, configure your wireless connection manually.
When WPS configuration is done, wireless connectivity will be established and the security encryption,
such as WEP or WPA-PSK, will be synchronized with the AP. Use the IW2 utility to find the camera. As
for IP setting, the camera's use of DHCP or static IP is determined by your configuration on the network
camera via the web-based configuration of firmware. The camera's default is DHCP.
WPS buttons
Wireless AP
2. Connect your camera using a LAN cable, open a web console, and enter the
Configuration
->
Wireless
page. Select the
WPS
checkbox, and click the
Save
button.
4. Wait for 2 minutes with the onscreen progress bar. The camera should then reboot.When the progress
bar disappears, disconnect your LAN cable. You can refresh or re-start your web console to see live
video.
