VIVOTEK
User's Manual - 81
Preset positions
If you select DynaDome/SmartDOME, Lilin PIH-7x00, or Pelco D, Pelco P protocol, Samsung scc643
protocol protocol as the PTZ driver and click the
Save
button, the
Preset Position
button will be enabled�
Click
Preset Position
to open the settings page� You can also select preset positions for the camera to
patrol. A total of 20 preset positions can be configured.
Please follow the steps below to preset a position:
1� Adjust the shooting area to the desired position using the buttons on the right side of the window�
The
default
Home
position is set as the center position�
2� Enter a name for the preset position, which allows up to forty characters� Click
Add
to enable the
settings� The preset positions will be displayed under
User preset locations
�
3� To add additional preset positions, please repeat steps 1~2�
4� Select the preset positions and click on
Save
to enable the settings�
5� The positions saved will show up in
Go to
drop down list on the Home page�
6� To remove a preset position from the list, select it and click
Remove
�
2011/06/10 17:08:56
Functions are the same
as the Control Panel on
the home page
1
4
6
2
5
■Transparent HTTP Tunnel: If you want to use your own RS-485 device, you can use UART commands
to build a Transparent HTTP Tunnel� The UART commands will be sent through HTTP tunnel
established between the RS-485 device and the linked camera� For detailed application notes, please
refer to URL Commands on page 112 or http://www.vivotek.com/downloadfiles/faq/videoserver/UART_
HTTP_Tunnel�pdf�
Summary of Contents for IP8151P
Page 1: ......
