VIVOTEK
User's Manual - 55
Please follow the steps below to setup a profile:
1. Check
Enable this profile
.
2. Select the applied mode: Day mode, Night mode,
or Schedule mode. Please manually enter a range
of time if you choose the Schedule mode.
3. Configure Exposure control settings in the folowing
columns. Please refer to previous dicussions for
detailed information.
4. Click
Save
to enable the setting and click
Close
to
exit the page.
You can click
Restore
to recall the original settings without incorporating the changes. When
completed with the settings on this page, click
Save
to enable the settings.
■ Exposure Time: The configurable max. exposure time is tunable according to lighting conditions
with values ranging from 1/10000 to 1/5 of a second.
■ Gain Control: Tune the slider bar to set the Gain Control to the best image quality. Higher gain
control value will generate a certain amount of noises.
■
WDR Pro
: When enabled, you can select the strength of the WDR function. The Low, Medium,
High options correspond to the level of contrast between the overly-lit area and the shaded areas.
For example, the High option applies to a high contrast scenario. Note that when the exposure
time is set to longer than 1/60 second, the WDR function will be disabled.
The Sensitivity option applies to the response speed to the change in bright-to-dark lighting
contrast.
If you want to configure another sensor setting for day/night/schedule mode, please click
Profile
to
open the Profile of exposure settings page as shown below.
Activated period
: Select the mode this profile to apply to the Schedule mode. Please manually enter
a range of time if you choose Schedule mode. Then check
Save
to take effect.
