VIVOTEK - A Leading Provider of Multimedia Communication Solutions
6 - User's Manual
Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the indented reset button with a paper clip or thin object� Wait for the
Network Camera to reboot�
Restore: Press and hold the reset button until the status LED rapidly blinks� It takes about 30
seconds� Note that all settings will be restored to factory default� Upon successful restore, the
status LED will blink green and red during normal operation�
Installation
Hardware Installation
1� Use the supplied screwdriver to detach the dome cover from the camera base� Then, follow
the steps below to install the camera; either to a ceiling or to a wall�
Installation Tips
Before installing the camera, look for a spot that best suits your needs� The built-in PIR sensor
is designed to be triggered when a person enters its detection range� Therefore, it is crucial to
install the camera at a place with the PIR sensor facing the desired direction� (The sensitivity
of PIR sensor depends on object size and temperature differences between the object and the
background environment�)
Reset Button
Status LED
I/O
Aud
io
Out
Mic.
In
Ext
.I
nt.
1
2
3
4
Top view
Side view
Summary of Contents for 4X-FD7132
Page 1: ......
