4K Home Distribution Hub
11
No.
EDID Data
1
1080P 2D 2CH
2
1080P 3D 2CH
3
1080P 2D Multichannel
4
1080P 3D Multichannel
5
3840x2160 2D
（
30Hz
）
Press a
nd hold “EDID” for 3 seconds to enter EDID invoking mode. In this mode, use
output buttons 1/2 to switch among the 5 embedded EDID data. Then press “ENTER”
to confirm invoking.
Format: Press and hold “EDID” for 3 seconds, INPUT# +OUTPUT1/2 + ENTER.
Invoke embedded EDID data for one input:
Example: set the EDID data of input 2 to the fourth type of embedded EDID data
→Press EDID (hold for 3 seconds to enter in EDID setting status) + INPUTS 2 +
OUTPUTS1 or 2 + ENTER
4.1.2.3. Clear operation
When you switch output channel, learn EDID data, or set EDID data, press “Clear”
button to EXIT the operation before you press “ENTER” to carry it on. When you press
it, the Matrix Switcher will return to the previous status.
Force Carrier
a)
Only if the IR receiver connected to HDBaseT receiver is with IR carrier, can the
received IR signal be transferred to IR OUT port of the Matrix Switcher.
b)
Only if the IR receiver connected to the Matrix Switcher is with IR carrier, can the
received IR signal be transferred to IR OUT port of the Matrix Switcher.
If the IR receiver connected to HDBaseT receiver or the Matrix Switcher is without
an IR carrier si
gnal, send the command “%0901.” to enter infrared carrier enforcing
mode, and then IR signal can be transferred to IR OUT port.
Control Far-end Device locally
Connect an IR receiver to IR IN on the Matrix Switcher, and use the IR Remote of far-
end device to control the device locally.
Connect an IR receiver with IR carrier to the IR IN port of the Matrix Switcher; users
can control far-end output displayer via its IR remote from local.
In that case, the IR signal is transferred via twisted pair. Only the corresponding IR
OUT port can emit control signals to the remote display.
See the figure below:
