Vivo LEDTV42FHD, Owner'S Operation Manual

Page: 12 / 31

11
In order to receive TV programs emitted by satellite, a satellite
receiver should be connected to the rear of the LED LCD TV. Mean
while, in order to receive encoded emit signal, a decoder should
be connected to the rear of LED LCD TV.
Using the coaxial cable
Connect the coaxial cable connectors to
The decoder output terminal.
The antenna input terminal.
If you want to connect the TV to satellite receiver (or decoder) and
video recorder at the same time, the following operation should be
followed:
Connect receiver (or decoder) to video recorder.
Connect video recorder to LED LCD TV, or connect receiver (or decoder)
directly to LED LCD TV.
♦
♦
♦
♦
In order to receive TV programs, signal should be received
from one of the following signal sources:
Outdoor antenna.
Cable TV network.
Satellite broadcast network.
1. In these three cases, the input cable of antenna or TV network
should be plugged in the 75 Ohm coaxial cable jack at the rear
side of LED LCD TV.
2. If you are using indoor antenna and the effect of TV program is
not satisfactory, you can adjust the position of the antenna until
the picture is clear.
When installing LED LCD TV, please use special 75 Ohm coaxial Cable.
If other coaxial cable is used, there may be noise and image
disturbances.
♦
♦
♦
Connecting to Satellite Receiver or Decoder
Connecting to Satellite Receiver or Decoder
LED LCD TV