5
STEP 3 - OPTION A: Left Side Extension
STEP 4 - OPTION A: Left Side Extension
Slide Inner Crossbar (N) into Right Crossbar (M) and Inner Right Crossbar (L). Secure using M6x12 Screw
(S-C) and 4mm Allen Wrench (T-C). Attach Crossbar Connector (O) to Inner Left Crossbar (K) and Left
Crossbar (J) using M6x12 Screw (S-C) and 4mm Allen Wrench (T-C). For correct position of Crossbar
Connector (O), use 1st and 2nd holes from left, and 2nd and 3rd holes from right.
S=4mm
Recommended
Installation Position
Rubber Pad(x19)
S=2mm
Assemble the rubber pad
T-C
S-C
N
G
H
Insert the Short Sync Rod (G) into Left Leg (D). Loosen the nut on the Short Sync Rod, then extend the
rod onto Center Leg (F) and tighten the nut. Insert the Long Sync Rod (H) into right side of Center Leg
(F) and extend the rod onto Leg with Motor (E) and tighten the nut. Tighten both set screws on the end
of the Short and Long Sync Rods (G, H) using the 2mm Allen wrench (T-B). Insert Rubber Pads (S-F)
into the desktop mounting holes in the desk frame assembly.
S-F
T-B
M
L
S-C
K
J
T-C
D
F
E
S-F
Loosen the nut
on the Sync Rods
(G, H).
Insert the Sync
Rods
(G, H)
into
the hex holes in
Legs
(F, D)
and
turn them counter
clockwise until they
it reach their lowest
positions.
Insert the other end
of Sync Rods
(G,
H)
into the slots on
Legs
(F, E)
. Secure
the Sync Rods
(G, H)
to the slots by
tightening the
pre-installed set
screw using 2mm
Allen Wrench
(T-B)..
Retighten the nut
O
T-B
T-B
S-F
Insert Rubber Pads
(S-F)
.
Retighten the nut.
