—
4
—
Rear view
I
TEM
L
ABEL
D
ESCRIPTION
S
EE PAGE
:
1.
POWER
Turns the projector on or off (main power switch must
be turned on first). Press to place the projector in
standby mode.
13
2.
3D SYNC OUT
Connect 3D IR glasses receiver unit.
3.
HDMI1
Connect the HDMI cable from a HDMI device.
4.
HDMI2 / MHL
Connect the HDMI/MHL cable from an HDMI/MHL device.
Note:
Set the Source to HDMI 1/MHL also can be charging connected
MHL compatible smart device as long as the projector Power On.
5.
COMPUTER
Connect a RGB cable from a computer or a video enabled device.
6.
YPbPr
Connect a component video enabled device.
7.
USB POWER
(5V-2A)
Connect a USB cable for USB host.
Note:
Support 5V-2A output as long as the projector Power On.
8.
IR receiver
Receive IR signal from remote control.
7
9.
SERVICE
For service use.
10.
12V OUT
When connected to the screen through a commercially available cable,
the screen deploys automatically on start up of the projector. The screen
retracts when the projector is powered off (see notes below).
11.
RS-232
Connects RS-232 serial port cable for remote control.
12.
VIDEO
Connect the composite cable from a video device.
13.
READY LED
Red
Lamp Lit , System stable, Lamp Fail
46
Flashing
Error code (See as LED indicator table)
14.
TEMP LED
Red
Over temperature
15.
PWR LED
Red
Standby, Over Temperature
Green
Lamp Lit , System stable
Flashing
Power on, Cooling, Error code (See as
LED indicator table)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
