Installation
Use the corresponding MountingSet to install your LoopDock. All MountingSets come with
specific mounting instructions.
Step 1
Carefully remove the lower rubber pad first and then the upper
rubber pad.
Proceed as follows:
- Open the iPad resting shelf by pressing the button down
completely. If the SquareDock is in a horizontal position, the shelf
must be gently lifted manually.
- Lift the lower rubber pad starting from the center of the
SquareDock (see photo). When the inlay has reached
approximately a 45° angle it can be carefully pulled out.
- Close the resting shelf and gently pull the upper rubber cushion
out.
Step 2
Carefully remove the four screws on the cover (see photo -
green
).
!! IMPORTANT:
Hold cover tightly when removing the final screw
to avoid damage from falling down.
Step 3
Carefully remove the cover by lifting it towards you and place the
cover in a safe spot.
Step 4
Plug the connecting cable from the MountingSet into the
SquareDock plug contact.
!! WARNING:
When inserting the SquareDock, make sure that the
connecting cable is not pinched or pulled, as this may damage the
cable.
!! WARNING:
If a power supply is located close to the SquareDock,
please connect the protective grounding wire (
yellow
) to the
protective conductor of the power supply. (for example InWall
MountingSet)
Step 5
The various fastening points for the SquareDock are easily
identifiable (
red
). Using the screws included in the MountingSet,
fasten the SquareDock.
!! IMPORTANT:
Please follow the instructions included with the
MountingSet.
Step 6
Place the cover on the SquareDock. The correct positioning is
dictated by the button. Thread the cover into place there. Fasten the
cover with the four screws and put the rubber pads back in place.