Vivax FS-40T, User Manual

Page: 33 / 52

base and tighten the screws. Slip decorative cover to base alongside the support tube and
adjust up-down tube to height. Then rotate tighten the external joint.
Second step: Assemble fan blade
1) Assemble guard cover and shroud ring
Tighten back cover enclosure to the motor by fastener. (Pay attention to direction of rotation).
Place joint of shroud ring downwards and cover the deep groove of shroud ring to the circle
side ring of back cover enclosure. Then tighten the bolts at the position of joint properly by
nut.
2) Install fan blade
While installing fan blade, please wedge groove on the back of fan blade on spacer pin of the
output shaft of motor. Then tighten the fixing nut of fan blade anticlockwise.
3) Assemble front cover
Insert the circle of front cover into the groove of shroud ring, which has been fixed to the
back cover. Finally fasten the bolts into screw of the joint of shroud ring.
Direction of use
1. Setting of wind direction
This fan can swing in up and down direction. The angle of facing upwards and downwards
can be adjusted by slightly lift or press the cover.
2. Setting of shaking
Press the turning button and the head starts to rotate. Then pull it out and fan will stop
rotating.
3. Setting of wind speed and wind type
Pressing button of wind speed can adjust the speed of wind.
4. Setting of timer (only for LDSO2 series and LDS03 series).
This fan can work 40min, 60min. 80min, 100min, 120min by setting the timer.
Solution to simple failure
When starting the fan, the fan blade doesn’t work. Please check whether the power plug has
really inserted into the socket or the cover has distorted, which has touched the fan blade. If
sound the noise when starting the fan, please check the unit as follows:
(1) Fan blade has been tight installed into the output shaft of motor.
(2) Groove on back of cover has matched the inserting groove on the output shaft.
(3) There are tiny defective edge ring existing around the fan blade.
(4) The cover has distorted, which has touched the fan blade.
Maintaining
Be sure to switch off the power supply and pull out the plug before cleaning.
1. This machine only needs common external cleaning and wiping.