Vivax CFR-102, Instruction Manual

Page: 68 / 96

ENG
VIVAX
13
• There should be more than 70 cm above the top of the appliance
and more than 20 cm on both sides and back of the appliance
to make it easier to open and close and distribute heat.
• Clean the inside and outside of the appliance with a warm damp
cloth (add a small amount of detergent in warm water and then
wipe with clean water).
• If you moved the device, wait half an hour before turning on the
power.
• The freezer should be operated for two to three hours before
you start putting fresh or frozen food; in case of higher room
temperature (eg. in summer), the freezer should be operated for
at least 4 hours before filling the appliance with food, and it must
be taken into account that the ambient temperature is high.
Cleaning
Dusts behind the fridge and on the ground shall be timely cleaned to improve the cooling
effect and energy saving.
The interior of the refrigerator should be cleaned regularly to avoid odor. Soft towels or
sponge dipped in water and non-corrosive neutral detergents are suggested for
cleaning. The freezer of shall be finally cleaned with clean water and dry cloth. Open the
door for natural drying before the power is turned on.
• Do not use hard brushes, clean steel balls, wire brushes,
abrasives, such as toothpastes, organic solvents (such as
alcohol, acetone, banana oil, etc.), boiling water, acid or
alkaline items clean refrigerator considering that this may
damage the fridge surface and interior.
• Do not rinse with water so as not to affect the electrical
insulation properties. Please use a dry cloth when cleaning
lighting lamps, temperature control knob and electrical
components.
Defrost
• Freezer shall be manually defrosted
• Unplug the freezer door and open the freezer door, remove foods and drawers before
defrosting.
• Open the outflow holes and drainage holes; indoor doors will naturally melt,