Vivax ACP-12CH35GEK, Service Manual

Page: 13 / 51

)XQFWLRQDQG&RQWURO
Press this button to go into the SLEEP operation mode. Press it again to cancel. This function is available in COOL , HEAT
(Only for models with heating function) or DRY mode to maintain the most comfortable temperature for you.
SLEEP: 7
●
●
●
●
●
1.Remove the battery cover plate from the rear of the remote controller. (As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Close the battery cover plate.
When replacing the batteries, do not use old or different types of batteries
If the remote controller will not be used for a long time, please
otherwise, it may cause malfunction.
remove batteries
to prevent batteries from leaking.
The operation should be performed in its receiving range.
It should be kept 1m away from the TV set or stereo sound sets.
If the remote controller does not operate normally, please take the batteries out
and replace them after 30 seconds. If still not operating properly.
Notes:
replace the batteries.
Fig.1
Fig.2
TIMER:
Press this button to initiate auto-on/auto-off timer. To cancel auto-timer program, press this button twice.
8
4
Replacement of Batteries
Press " + " and " - " buttons simultaneously to lock or unlock the keypad. If the remote controller is locked , is displayed
I n this case, press ing any button, blinks three times.
At unit OFF , press "MODE " and " - " buttons simultaneously to switch between and .
Combination of "+" and "-" buttons: About lock
9
Combination of "MODE " and "-" buttons: About switch between fahrenheit and cenrigrade
10
About Lamp
Under switch-on or switch-off state, you may hold "+" and "FAN" buttons simultaneously for seconds to set the lamp on or
3
off and send the code. After being energized, the lamp is defaulted on.
Combination of "+" and "FAN" buttons: 11