Vivax ACP-07CIFM21GEEI, User Manual

Page: 159 / 212

★
●
●
●
●
●
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
When replacing the batteries, do not use old or different types of batteries,
If the remote controller will not be used for a long time, please
otherwise, it may cause malfunction.
remove batteries to prevent batteries from leaking.
The operation should be performed in its receiving range.
It should be kept 1m away from the TV set or stereo sound sets.
If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds. If it still can't operate properly,
Notes:
replace the batteries.
Operation of wireless remote controller
Sketch map for
replacing batteries
Replacement of Batteries
Press "+" and "-" buttons simultaneously to lock or unlock the keypad. If the remote
controller is locked, is displayed. In this case, pressing any button, blinks three
times.
At unit OFF, press "MODE" and "-" buttons simultaneously to switch between
℃ ℉
SLEEP:
LIGHT:
16
17
Press LIGHT button to turn on the display's light and press this button again to turn off
the display's light. If the light is turned on, is displayed. If the light is tunrned off,
disappears.
Combination of "+" and "-" buttons: About lock
18
Combination of "MODE" and "-" buttons: About switch between Fahrenheit and Centigrade 19
11
and .
Press this button to go into the SLEEP operation mode. Press it again to cancel this
function. This function is available in COOL, HEAT (Only for models with heating
function) mode to maintain the most comfortable temperature for you.